DIY Sarah

Craft, Decor, Art, Garden, and Dessert

Patching Drywall – The Wolpert Method

We’ve done a good bit of patching lately.  Here’s the tried and true method.

Step 1: make your ugly hole:

IMG_3181.JPG

Step 2: make a template of the hole:

IMG_3179.JPG

use any circles or other shapes you need to make it perfect

Step 3: Cut out template from drywall. We used a Roto-zip but a drywall saw works too.

IMG_3178.JPG

Step 4: test-fit and adjust if necessary.
IMG_3184.JPG

Step 5: tape using mesh fiberglass tape:
IMG_3189.JPG
(different hole but you get the picture.)

Step 6: Mud:
IMG_3187.JPG

Steps 7-10: sand, mud, repeat

Step 11: Prime

Step 12: Paint
IMG_3246.JPG

 

(Stefan’s blurry but look how good that ceiling looks.  Also, this is THE book.  I was holding it up so Stefan could see the diagram for how to wire a 4-way switch.)

Step 13 (Optional): cover your mediocre patch job with a ceiling medallion
IMG_3256.JPG

And Voila… no more holes in the ceiling.

Oh, and I forgot to mention steps 14 and 15… vacuum, mop, repeat to get all that sanding dust off the floor… lots of dust…

The real key here is the sand, mud, repeat step. If you don’t worry too much about getting it perfect and plan on several rounds of sand-mud-repeat, you’ll end up with a nice smooth finish. It’s messy but once you’ve sanded once, another round isn’t going to add much in the way of clean-up.

We’d love to hear any of your patching tips in the comments!

Sarah (and Stefan, mudder extraordinaire!)

 

Categories
Uncategorized
  1. 7/5/2013 | 2:26 pm Permalink

    We haven’t used it yet, but Easy Sand plaster would speed up the mud and sand cycle. Premixed lightweight plaster takes 12+ hours to dry, whereas Easy Sand comes in cure times as short as 5 minutes up to 2-3 hours. The number after the Easy Sand product indicates the nominal amount of cure time in minutes. We opted for a bag of Easy Sand 45 to give us plenty of open time. The Easy Sand spec sheet states a cure time of 30-80 minutes for Easy Sand 45, so the open time (before it starts getting thick) is likely only 10-20 minutes. The pros we had do our bigger plastering job used Easy Sand 20, and I bet this would only allow for a couple trowel passes before not being able to touch it anymore.